This site uses cookies to offer you a better browsing experience. Further information is on our Privacy Policy page. Please click Accept Cookies to continue to use the site.

Voopoo Argus Top Fill 2ml Replacement Pods, 0.4ohm, pack of 3

Voopoo Argus Top Fill Replacement Pods

(No reviews yet) Write a Review
£7.99

Further Information

If your Argus pod has started tasting burnt, gurgling on the draw, or simply won't seal at the top any more, this is the cartridge that gets it back to day-one flavour. The Voopoo Argus Top-Fill Replacement Pod is the standard 2ml cartridge fitted across the whole Argus pod system range, from the original Argus G through to the newest G3 and P3, and it's sold here exactly how Voopoo intended: a magnetic drop-in fit, a top-loading fill port so you're not hunting for a hidden side plug, and a built-in mesh coil that's ready to vape the second it's out of the packet.

We stock all three standard resistances (0.4 Ohm, 0.7 Ohm and 1.0 Ohm) plus the newer V2 cartridge in the same three resistances, so whichever Argus device is sitting on your desk, there's a pod here that fits it properly. Each pack contains three 2ml TPD Compliant pods.

 

Vaping products are for adult smokers and existing vapers only. Not suitable for non-smokers or those under 18.

 

KEY FEATURES

  • Genuine Voopoo Argus top fill cartridge, compatible with the wider Argus pod family
  • 2ml e-liquid capacity (UK TPD-compliant fill volume)
  • Top fill design: no need to remove the pod from the device to refill
  • Magnetic pod connection for a secure, wobble-free fit
  • Built-in mesh coil, replaced as a whole unit for consistent flavour every time
  • Durable PCTG pod body that resists cracking and staining
  • Available in 0.4 Ohm, 0.7 Ohm, 1.0 Ohm and the newer V2 cartridge in the same three resistances
  • V2 cartridge adds Voopoo's Liquid-Seal Shield leak-proofing and a Mega-Core coil for longer-lasting flavour
  • Suits both mouth-to-lung (MTL) and restricted direct-to-lung (RDTL) vaping styles depending on resistance chosen

WHAT'S IN THE BOX?

  • 3 x Voopoo Argus Top Fill Replacement Pods (resistance and generation as selected at checkout)
  • No device, coils are pre-installed and sealed inside each pod
  • No e-liquid included

FULL SPECIFICATIONS

  • Brand: Voopoo
  • Product: Argus Top Fill Replacement Pod, pack of 3
  • Pod material: PCTG
  • Coil type: Integrated mesh coil (non-replaceable, whole pod is swapped)
  • E-liquid capacity: 2ml
  • Fill method: Top fill, magnetic silicone bung
  • Pod connection: Magnetic
  • Resistance options: 0.4 Ohm, 0.7 Ohm, 1.0 Ohm (standard); 0.4 Ohm V2, 0.7 Ohm V2, 1.0 Ohm V2
  • Recommended wattage, 0.4 Ohm: 18–30W
  • Recommended wattage, 0.7 Ohm: 14–18W
  • Recommended wattage, 1.0 Ohm: approximately 9–14W
  • Vaping style: MTL (1.0 Ohm and 0.7 Ohm) to RDTL (0.4 Ohm)
  • Recommended e-liquid base: 50VG/50PG
  • Typical pod lifespan: around two weeks with regular daily use, depending on e-liquid and habits

DIMENSIONS & WEIGHT

These figures are for a single pod, taken from the standard Argus pod cartridge shape used across the range. Individual devices can adjust the overall handling size slightly, but the pod itself doesn't change dimensions between compatible Argus kits.

Per pod:

  • Metric: approximately 3.3cm (H) x 2.5cm (W) x 1.3cm (D), 7.3g
  • Imperial: approximately 1.3in (H) x 1.0in (W) x 0.5in (D), 0.26oz

Per pack of 3:

  • Metric: approximately 22g
  • Imperial: approximately 0.05lb / 0.78oz

COMPATIBILITY GUIDE

The Argus Top Fill Replacement Pod fits the Argus pod system family that uses the top fill cartridge, including:

  • Voopoo Argus G2
  • Voopoo Argus A
  • Voopoo Argus Z (top fill variants)
  • Voopoo Argus G3 and G3 Mini
  • Voopoo Argus P2 and P3

The V2 cartridge is Voopoo's updated version of the same pod, introduced alongside the Argus G3, and is cross-compatible with the original Argus and Argus top fill devices as well. If you're not certain which generation your device takes, check the resistance printed on your current pod against the options above, or the model name printed on the device itself.

Not compatible with: the older side-fill Argus pod (0.7 Ohm / 1.2 Ohm), used on the original Argus Pod, Argus P1 and early Argus G. If your device has a concealed side rubber bung rather than a top opening, you need our Voopoo Argus Replacement Pods (side-fill) instead.

Shop compatible devices:

COIL / POD RESISTANCE GUIDE

  • 1.0 Ohm: the tightest draw of the three, closest to a cigarette-style pull. Best for smokers using higher-strength nic salts who want a subtle, restricted inhale.
  • 0.7 Ohm: the most popular middle-ground option. A slightly looser MTL draw with a good balance of flavour and vapour, suited to most 10mg and 20mg nic salts.
  • 0.4 Ohm: a looser, warmer RDTL draw with noticeably more vapour. Works best with 50/50 e-liquids or nic salts rather than very high-VG juice, since the wicking ports are sized for the Argus format.
  • V2 versions: same three resistances, built on Voopoo's newer Mega-Core coil with Liquid-Seal Shield leak protection, aimed at slightly longer flavour life and reduced leaking over the life of the pod.

USAGE ADVICE

Prime a new pod before vaping it. Drip two or three drops of e-liquid directly onto the visible coil mesh through the fill port before you top up the tank, then let it sit for five minutes so the wicking material can fully saturate. Vaping a dry coil, even briefly, is the most common cause of a harsh, burnt first draw.

To fill, lift or twist the top silicone bung (this varies slightly by device generation) and fill slowly against the inside wall of the pod rather than straight down the middle, to avoid air bubbles that can cause gurgling. Fill to just below the maximum line and reseal the bung firmly, as an incomplete seal is the main cause of top fill leaking.

Give the pod a minute after refilling before your first draw, and start any new pod at the lower end of its recommended wattage range for the first few puffs.

RECOMMENDED E-LIQUIDS

Nic salts are the natural pairing for the Argus pod format, since the tighter wicking is built for lower-powered MTL and RDTL vaping rather than high-VG sub-ohm juice.

New to nic salts? Read our guide on what nic salt e-liquid is and how it works before choosing a strength.

FAQs

Are these pods genuine Voopoo? Yes. We stock genuine Voopoo Argus Top Fill Replacement Pods sourced through official channels, not third-party clones.

Which Argus devices do these pods fit? The top fill Argus pod fits the Argus G2, Argus A, Argus Z (top fill variant), Argus G3, Argus G3 Mini, Argus P2 and Argus P3. It does not fit the original Argus Pod, Argus P1 or early Argus G, which use the older side-fill Argus Replacement Pods instead.

What's the difference between the standard pod and the V2 pod? The V2 cartridge is Voopoo's updated version, introduced with the Argus G3. It uses a Mega-Core coil and Liquid-Seal Shield leak-proofing aimed at longer flavour life and less leaking over the pod's lifespan. Both generations are 2ml, magnetic and top fill, and the V2 pod is cross-compatible with original Argus top fill devices too.

How do I know which resistance my device needs? Check the resistance printed on your current pod, or your device's manual. Most Argus kits ship with a 0.7 Ohm pod as standard, with 0.4 Ohm and 1.0 Ohm sold separately for a looser or tighter draw.

How long does one pod last? Around two weeks with regular daily use, though this varies with how often you vape and which e-liquid you're using. Sweetened or heavily flavoured e-liquids tend to shorten coil life.

Can I use these pods with high-VG e-liquid? We wouldn't recommend it. The Argus pod's wicking ports are designed for 50/50 e-liquids and nic salts. High-VG juice is thicker and can struggle to wick properly, leading to dry hits.

Why is my new pod leaking from the top? This is almost always an incomplete seal on the fill bung after topping up, or overfilling past the maximum line. Make sure the bung clicks fully back into place and you leave a small air gap at the top.

Why does my pod taste burnt straight out of the packet? The coil needs priming. Add a few drops of e-liquid directly to the coil through the fill port and let it sit for five minutes before your first vape.

Can I refill the pod without removing it from the device? Yes, that's the main benefit of the top fill design. Lift or twist the top bung and fill directly while the pod stays seated in the device.

Is the 2ml capacity a Voopoo limitation or a UK rule? It's a UK regulation. The Tobacco Products Directive limits refillable vape tanks and pods sold in the UK to a maximum 2ml capacity, regardless of what capacity the same pod is sold at elsewhere in the world.

Which resistance is best for someone switching from smoking? The 1.0 Ohm pod gives the tightest, most cigarette-like draw, which tends to suit new switchers best when paired with a 20mg nic salt.

Do these pods work with nic salts and freebase e-liquid? Yes, both work, though nic salts are the more common pairing for MTL and RDTL pod devices because of how they deliver nicotine at lower wattages.

How often should I replace the pod, even if it's not leaking? Most vapers notice a drop in flavour and vapour production after two to three weeks of regular use, which is a sign the coil is due for replacement even without visible leaking.

Can I buy just one resistance, or do I need to buy a mixed pack? Each pack of three pods is a single resistance, so pick the one that matches how your device is currently set up, or the draw you're after.


Vaping products are for adult smokers and existing vapers only. Not suitable for non-smokers or those under 18.


 

AUTHOR

Written by Joe Delaney, Senior Vape Product Specialist at V2 Cigs UK. Joe has worked with the Voopoo Argus range since its original launch and tests every new pod generation before it's added to the site. 

 

Customer Reviews

Write a Review
This product hasn't received any reviews yet. Be the first to review this product!

Related Products